Shaper rings
#1
I am making some shaper rings. They are 3/4" thick,  6.5" OD, will get turned down to 5.950. The inner dia on some will be 4-5" so that's a lot of boring and swarf.

What's the best way to do this? Can I cut out the ID close to required on the rotary table on the mill, then finish it up on the lathe? That way I still get a usable piece of aluminum that gets cut out of the middle.

Thanks.
Steve S
Check out MyShopNotes on youtube.
Reply
Thanks given by:
#2
If you already have round plates to start with, I'd trepan on the lathe this way:

Face one side clean. Using a trepanning tool, plunge a face groove to 1/2 the depth of the thickness. Be exact about how far in you actually go. Flip the part in the chuck, clean the other face. Measure thickness, then plunge a trepan tool to within .005" to .010" of the face groove on the back. Do NOT break through with the lathe spinning as you don't want a kg of sharp edged aluminum disk shooting at you.

Remove from chuck, give the center section a good whack with a soft face hammer being careful t catch it with a leather of other protective glove. Now you have a usable slug.
Reply
Thanks given by:
#3
Or a hole saw in the tailstock.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:
#4
A hole saw that size would be troublesome, methinks. It would take a LOT of power and I think it would just stall a machine. In that size you can barely cut a decent wood.
Reply
Thanks given by:
#5
Use them all the time Ken, in aluminum that Ken's using I wouldn't even bother with coolant, just a shot of WD40. A hole drilled on the periphery of the circle to clear chips helps speed up the cut.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:
#6
I wouldn't hesitate to use a hole saw 4-5" dia. in either of my lathes, heck If I can use it in a 1/2 electric drill.
I do recommend Greg's suggestion of a hole or 2 on the periphery for chip control.
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:
#7
I've used large hole saws a few times too and know they can work if you just take it easy. The difference between using one and trepanning is night & day though. Trepanning leaves you with a blank that has no hole in the middle, and it just plain works so easy.
Reply
Thanks given by:
#8
I wanna know what a shaper ring is.
Reply
Thanks given by:
#9
(12-13-2014, 10:02 AM)Sunset Machine Wrote: I wanna know what a shaper ring is.

And me Smile
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#10
Ditto.  Smile
Willie
Reply
Thanks given by:




Users browsing this thread: 3 Guest(s)