Posts: 2,596
Threads: 99
Joined: Dec 2014
Location: Michigan
The following 1 user Likes Vinny's post:
Highpower (12-23-2015)
If it were me, I'd go with two, but there's no engineering schooling on mine either.
Posts: 1,827
Threads: 51
Joined: Apr 2012
Location: Oklahoma
12-23-2015, 05:44 PM
(This post was last modified: 12-23-2015, 05:45 PM by dallen.)
take it off both sides so the key stays centered. that's from putting 100 HP drives together with a stepped key in them.
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough! 
Posts: 4,368
Threads: 178
Joined: Feb 2012
Location: Missouri, USA
(12-23-2015, 05:44 PM)dallen Wrote: .... that's from putting 100 HP drives together with a stepped key in them.
Sounds good enough to me! Thanks guys.
Willie
Posts: 3,002
Threads: 51
Joined: Apr 2012
Location: Ontario
Late reply Willie but any stepped keys I've seen are cut on both sides.
Free advice is worth exactly what you payed for it.
Greg
