P&W 1830 Radial in 1/6 scale.
#21
Minor misunderstandings. Unfortunately, it's the nature of the beast, the internet that is. Let's just concentrate on the wonderful build thread Bill has started. We're all here to learn and enjoy exchanging information about metalworking.

Ed
Reply
Thanks given by:
#22
Looking good so far Bill. Do you have a pic of what the end result will be, so we can see what you are building towards?
Hunting American dentists since 2015.
Reply
Thanks given by:
#23
Hopefully it will be close to this Darren.

"Billy G"


Attached Files Thumbnail(s)
   
Reply
Thanks given by:
#24
Bill,

Wow, this is going to be one great build, really looking forward to it Bill.

Smiley-eatdrink004
Dave
Reply
Thanks given by:
#25
I agree Dave! I'll be following this with interest Bill.
Hunting American dentists since 2015.
Reply
Thanks given by:
#26
Bill,

That's one serious project you're embarking on. Good luck and we'll all be watching this thread, I'm sure.

Ed
Reply
Thanks given by:
#27
Thanx everyone. Sometimes a little encourgement helps to continue.

Next up was the Super Charger housing. Lots of boring here. It fits just ahead and is attached to the Gearbox.

"Billy G" Big Grin


Attached Files Thumbnail(s)
           
Reply
Thanks given by:
#28
Bill
That is a fine looking engineDroolDrool
You are making a great start
Keep the pictures comingBig GrinBig GrinBig GrinBig Grin
John
Reply
Thanks given by:
#29
Thanx.

Before moving ahead I wanted to do the oil pump. This was a nasty little bugger to do.The pix shows the print and blanks. Also some special tooling had to be made. It is an adustable center arbor for the faceplate.

"Billy G" Big Grin


Attached Files Thumbnail(s)
       
Reply
Thanks given by:
#30
Gear blanks had to be made.

"Billy G" Big Grin


Attached Files Thumbnail(s)
   
Reply
Thanks given by:




Users browsing this thread: 4 Guest(s)