MetalworkingFun Forum

Nice shop Videoman. Don't know how you guys keep your shops so clean I'd be ashamed to post photos of mine, I had the exact same 14 x 40 lathe only under a different brand in Canada.

Thanks, guys, appreciate your comments. I forgot to mention I have one of those grizzly 7 inch surface grinders and a little electronics bench which are to my back as you look at the mill. I'll get the camera out and add that, if anybody is interested. Don't be bashful about a cluttered shop, though. Cluttered shop is probably a busy shop. I admit to not having enough real projects to justify all this stuff, I am a toolaholic. I do some repairs for the railroad museum, although they have a great old Hendey lathe, and invariably have some friend with a boat or something who needs "just this one little simple thingy". And I make little metal chips out of perfectly good stock just to keep in practice!

Nice looking set up videoman.

William,

Being a toolaholic is almost a requirement for this forum so you're in good company.

Ed

My shop.......well at least half of the Cnc side of it. The other half is out of camera shot.

This is in my 24' x 46', 3 car garage I added on back in 2004.

Radiant heat in the floor, fully air conditioned in the summer........yes folks......there's no place like home!

All my manual machines are in another section of the basement.


Best Regards,
Russ

Nice setup Russ! You can never have too much shop space.

Ed

Russ,
Very nice

DaveH

Words fail me
John

Ya, But.. but...er..um! (and you think words fail YOU John.)

(10-06-2012, 01:25 PM)wrustle Wrote: [ -> ]My shop.......well at least half of the Cnc side of it. The other half is out of camera shot.

This is in my 24' x 46', 3 car garage I added on back in 2004.

Radiant heat in the floor, fully air conditioned in the summer........yes folks......there's no place like home!

All my manual machines are in another section of the basement...

And my wife complains about our power bill