It looks like it's resting peacefully!!
(06-15-2022, 12:07 PM)EdK Wrote: [ -> ]Made some inserts for the t-slots to keep the swarf out.
Ed
Some sheet metal covers also work well. When push comes to shove so do some red shop towels.
(06-20-2022, 06:26 AM)Dr Stan Wrote: [ -> ] (06-15-2022, 12:07 PM)EdK Wrote: [ -> ]Made some inserts for the t-slots to keep the swarf out.
Ed
Some sheet metal covers also work well. When push comes to shove so do some red shop towels.
I've got some neoprene rubber left over that will fit on both sides of the vise so I plan on using it to cover the table also.
Ed
Made one of these for my brother for his birthday last month. Bought the spotting drills to fill it up and sent it off to him. I figured I should have one also but I need to get the two larger sizes. The super glue got away from me.
Ed
[
attachment=17934] [
attachment=17933]
Acetone will take that off. Don't soak it, or it will soften the joint as well.
(06-22-2022, 03:26 PM)EdK Wrote: [ -> ]Made one of these for my brother for his birthday last month. Bought the spotting drills to fill it up and sent it off to him. I figured I should have one also but I need to get the two larger sizes. The super glue got away from me.
Ed
Just out of curiosity guys, which point angle do you prefer for your spotting drills?
Personally, I just use center drills for everything.