MetalworkingFun Forum

Looks good Rob  
 
DaveH

Lookin good Rob! Time to fire that baby up!

Meanwhile  I was getting sick of moving gear about the workshop this morning  I decided to upcycle (snigger,  )  my  Cupola blower . 





The motor will be used re used sometime in the future , the fan I think will be used on the forge as the extractor and the wee stand became a hammer and tong rack .





Cheers Rob 

Rob, are you quite sure you have enough pairs of tongs?


Nice work!
Phil

(02-14-2016, 02:28 PM)hermetic Wrote: [ -> ]Rob, are you quite sure you have enough pairs of tongs?


Nice work!
Phil

NOPE !      I could do with a few more Phil    



Rob 

I have just had a brain fart   , I think I will sink a couple of bits of 3" tube into the top to hold punches ,drifts and chisels  


Rob

Nice idea -- kinda like a commercial kitchen, I like it.

Make sure you drill a few holes in the bottom for the inevitable grit & junk to get swept out.

Well I grabbed an hour in the shop tonight and added two square pockets to hold punches and the likes . one 6" deep and the other 4" deep .






Rob

I quite like that, nice coat of paint . No idea what I would need it for but that's never stopped me in the past.
 
DaveH

For your barbecue tackle mate      



Rob