Rob,
What type of welder are you using? Nice job of welding up the sculpture.
Ed
Hi Rob , coming along nicely
, I do like to see a robust job getting done
, not like the S***E on sale new everywhere these days,there would only be the odd tack weld on the finished job.
I dont think yours will come to much harm if it takes a knock
Cheers Mick
Nice work Rob. I do enjoy reading your build threads.
Thanks for the comments Lads
(08-06-2014, 03:57 PM)EdK Wrote: [ -> ]Rob,
What type of welder are you using? Nice job of welding up the sculpture.
Ed
Hi Ed , my welding set up is nothing special just a welder from Machine Mart
It dose what I need of it , had it about 10 years and haven't killed it yet
(08-06-2014, 04:37 PM)Micktoon Wrote: [ -> ]Hi Rob , coming along nicely , I do like to see a robust job getting done , not like the S***E on sale new everywhere these days,there would only be the odd tack weld on the finished job.
I dont think yours will come to much harm if it takes a knock
Cheers Mick
I here you Mick ,,,,,,,,,,,never buy a Doosan forklift the welding on those is very poor , I think they should be re branded as DooDoosan
Well tonight's offerings ,not much but better than nowt
, finished off the welding ,ground off the weld flush on the underside of the top flange .
and ground up and rounded off the edge of the top face of the top flange .
Just need to cut a hole into the hearth to fit the fire pot .
Cheers Rob
Cheers Bob
A tad more done yesterday ,I got the hole cut into the hearth for the fire pot .After laying out I drilled out the corners with a hole saw ,this is so I would have rad corners, it also gave me a chance to try out the slow air drill John DB gave me ,one of his boot sale finds. It worked a charm.
Next joined the holes with the oxy torch .
A wee clean up with the grinder .
Jobs a good un.
Cheers Rob
Nice work Rob.
You'll have so much thermal mass in that hearth you'll burn yourself on it the following day !
Cracking job
Pleased the drill worked ok
Can I have the bit out of the middle
John
(08-10-2014, 02:47 AM)awemawson Wrote: [ -> ]Nice work Rob.
You'll have so much thermal mass in that hearth you'll burn yourself on it the following day !
Cheers Andrew ,,,,,,,,,,lol it will not be the first time I burn myself
(08-10-2014, 02:50 AM)doubleboost Wrote: [ -> ]Cracking job
Pleased the drill worked ok
Can I have the bit out of the middle
John
yer sure , What do you want 3/8 plate for mate ?
Rob