Nice job Ed .. I didnt have these step blocks on my to do list but since i saw them again and ya did such a nice job you gave me inspiration to putem on the list . Right now i started on a set a paralels or my new mill vice, once im done with them i may start this project .
I like the thumb knob design w/ the added touch . Did you press fit make (a 2 pc knob) or other thanks
again Nice Job
(09-14-2015, 03:14 PM)Kennyv Wrote: [ -> ]Nice job Ed .. I didnt have these step blocks on my to do list but since i saw them again and ya did such a nice job you gave me inspiration to putem on the list . Right now i started on a set a paralels or my new mill vice, once im done with them i may start this project .
I like the thumb knob design w/ the added touch . Did you press fit make (a 2 pc knob) or other thanks
again Nice Job
Thanks Kenny.
I pinned the knob to the bolt using a brass pin so it doesn't show up. There's not a lot of pressure on the knob since it's just used to keep the leafs from flopping around when using them and when on the shelf.
Ed
I like your one better Ed.
Ed
i was in the middle of designing a tailstock for my RT and an indexer i am going to purchase, thats a perfect design i need, very clever. Nice work on your one as well very sleek....
Anthony.
Very Nice Job Ed Clean slick ...
On the spin indexer tailstock what is the function of the big knob?
thanks again nice work .. lots of new ideas
Ed thanks yes i fig you pinned Bolt to knob but i was referring to the knob outside and inner diam looks like a press fit or thats cosmetic?
(09-16-2015, 01:46 PM)Kennyv Wrote: [ -> ]Very Nice Job Ed Clean slick ...
On the spin indexer tailstock what is the function of the big knob?
thanks again nice work .. lots of new ideas
Ed thanks yes i fig you pinned Bolt to knob but i was referring to the knob outside and inner diam looks like a press fit or thats cosmetic?
The big knob is for locking the arbor once you've got it into position.
The knobs for the step blocks are made of one piece of brass. Maybe that decorative circle on the top is fooling you into thinking it's a two-piece part. I put that in with a 'V' shaped tool bit just for decoration.
Ed