MetalworkingFun Forum

(11-20-2016, 05:01 PM)Dr Stan Wrote: [ -> ]Installing it into the spindle should be a piece of cake.  Just lay a piece of wood on top of the table or the vice, set the flycutter on the wood, roughly center the spindle over the cutter, lower the spindle then tighten the draw bar.

BTW, that's a very fine job of machining.

Hello Doc
Yes, that's a good idea for installation.
Muchas Gracias for the kind words. All U Guys are indeed overly generous with praise.
Need to go and throw some sand on my dials (face !!)
aRM

(08-15-2015, 10:37 AM)RobWilson Wrote: [ -> ]OK last tool/attachment  ,,,,,,,,,,,,,,,,,,,,,,,,, its getting boring looking at my own work , one thousand plus members  and only a hand full of lads making there own tools ,,,,,,,,,,, whats everyone else doing,,,,,, armchair engineering, or getting UPS  to deliver them .  


Tapper turning attachment for the Myford Super 7 lathe . 
















I lost the photos of it attached to the lathe when new , so these will have to do .







Rob

Just came across this thread . Rob ,your work is exquisite true masterclass of quality .

(12-04-2016, 03:33 AM)Seanlogie Wrote: [ -> ]

(08-15-2015, 10:37 AM)RobWilson Wrote: [ -> ]OK last tool/attachment  ,,,,,,,,,,,,,,,,,,,,,,,,, its getting boring looking at my own work , one thousand plus members  and only a hand full of lads making there own tools ,,,,,,,,,,, whats everyone else doing,,,,,, armchair engineering, or getting UPS  to deliver them .  

Tapper turning attachment for the Myford Super 7 lathe . 
I lost the photos of it attached to the lathe when new , so these will have to do .
Rob

Just came across this thread . Rob ,your work is exquisite true masterclass of quality .

This is tool porn at its best
It's a kind of magic the way this Master goes about manipulating steel to such beauty and perfection
Truly inspirational
aRM

Hi Guys.
We have also been active, to our own (limited) potential, and which is no way in comparison to what Maestro Rob's produces.
Made a set of large Machinist's Jacks, which we sorely missed when we were working on the Wheel Balancing stand. (See pics in Thread)
These are similar to what we had seen and liked on another site.  Nothing to fancy, but quite practical and useful.
Next we'd like to fabricate a smaller set.
Thanks for looking
aRM

[attachment=13951][attachment=13952]

Very nice Arm.

is me mill not clast as home made

  It is to me Bob

  Cheers Mick

(12-05-2016, 03:30 PM)krv3000 Wrote: [ -> ]is me mill not clast as home made

Of course it is Bob.

Ed

I keep making things but forget to to do pics

just dun a lod of D.T.I.s for john for got the camera needed charging