#1 very close to finished. Some relieving and shaping yet. I will get #2 to this point and finish them both at the same time. That is a blank that #1 is resting on. Much waste.
"Billy G"
And then there were two almost done. LOL
"Billy G"
Really nicely done Billy
DaveH
Bookmatched, they are a done deal.
"Billy G"
(05-09-2013, 05:00 PM)Bill Gruby Wrote: [ -> ]Bookmatched, they are a done deal.
"Billy G"
Very nice Bill
Small parts scare me
John
The "pucker factor" went up considerably while doing these John.
"Billy G"
Excellent craftsmanship Billy. Those are really small parts.
Ed
Delrin arrived Friday . I have one Distributor cap blank - ready to mill. I will get the other to this point then mill them both.
"Billy G"
That's two. Into the mill tomorrow then back into the lathe to finish up.
"Billy G"
10 -- .125 X .406 holes done. This one goes back to the lathe. One more to go.
"Billy G"