MetalworkingFun Forum

I see duct tape, must have shipped from GA  ...............

.. I just kill myself sometimes

greg

(11-04-2016, 03:11 AM)RobWilson Wrote: [ -> ]...I could not go fuchsia as it would be seen as copying Darren's shop colour scheme

It's not fuchsia, it is Dulux dog cock pink. It is a limited edition colour from their premier collection.

(11-03-2016, 08:59 PM)Vinny Wrote: [ -> ]Ed, I think it's the diamond plate look he doesn't like.

Oops! My bad.

Ed

Today a book I bought arrived, an unsoiled 15th edition of Machinery's Handbook. Inside the back cover was an envelope from ""The Institute of Mechanical Engineers" dated 1957 which had a receipt in it for money paid to bypass taking an exam. Unless I'm lost in translation, this sounds like a back hander to me, lol.  Nice book though !

(11-04-2016, 08:14 AM)Mike E. Wrote: [ -> ]Today a book I bought arrived, an unsoiled 15th edition of Machinery's Handbook. Inside the back cover was an envelope from ""The Institute of Mechanical Engineers" dated 1957 which had a receipt in it for money paid to bypass taking an exam. Unless I'm lost in translation, this sounds like a back hander to me, lol.  Nice book though !

Looks to be in great shape!

Got up opened the garage doors, expecting a carpenter to come by for me to weld up a gate hing. Gave him an hour, decided to my own stuff. If he shows fine I can stop to collect some quick cash.

So I did this V .......  Gained a bunch of room moving the mill too the wall also. Now have so much, the welding table attached to the bench can once again fold down as designed, just need to fab a rack for the clamps.

The lathe arrived on Tuesday........ same driver that brought the mill a year ago delivered the lathe.... Remembered the HotRods...

"Drain the swamp"

greg



[attachment=13880]

[attachment=13881]
caulking is there to prevent oil from going under the lathe and leaking into the cabinet.

[attachment=13882]

[attachment=13883]

[attachment=13884]

Looks good and nice use of the space. Hard to tell from the pic but do you have full travel on the x axis of your mill?

DAMN!! That's a nice looking unit!!

Very nice Greg 


Cracking workshop 



Rob

I'm seriously liking the PM equipment, but deeply concerned about the floor, way too much of it is visible.....