MetalworkingFun Forum

That's no excuse, most of us are old farts.  

Check out the tutorial in the Forum Issues and Discussions section.

Tom

(12-08-2018, 09:31 PM)Downwindtracker2 Wrote: [ -> ]Sorry ,I'm a old phart. my computer skills are pretty light. .....

This is the tutorial Tom was referring to.

How To Attach Pictures

Ask if you have questions.

Ed

The part that gets me is the "assuming the picture is on your hard drive"

Seriously though, sometimes a photo is very necessary to explain something, my jack shaft adjustment on the baby shaper is worthy, even the shop built 6" baby shaper is interesting. It's purple sorta and orange. But a Mitutoyo micrometer?

(12-09-2018, 10:29 PM)Downwindtracker2 Wrote: [ -> ]But a Mitutoyo micrometer?

The "rule" here is "If there's no pic, then it didn't happen".   I didn't make the rule as it was in place when I joined.

Lol. I forgot there was an actual rule. 

(12-09-2018, 10:29 PM)Downwindtracker2 Wrote: [ -> ]The part that gets me is the "assuming the picture is on your hard drive"

Then just post a link to it.

Ed

I got lucky, and was finally able to acquire a long sought after taper turning attachment for my Boxford lathe. Its complete, was carefully packaged, and in very good condition; Thank you Mark Lord.
Christmas comes early, happy day !  

Had 2020's firewood delivered yesterday. In kit form, some disassembly required, thankfully there's a wood processor hiding in the shed.

Sweet! How is the old professor working these days? Any recent upgrades?

Tom

Its been working pretty good Tom. Cut three loads like this with it last summer. The one load had some really big oak in it, my tractor wouldn't lift the logs, had an excavator with a thumb to load them.