MetalworkingFun Forum

(05-22-2023, 06:25 AM)rleete Wrote: [ -> ]Copycat.

Affirmative.

Ed

I've been wanting a set of these for a while.  I needed an M6 one for the mill power feed and ended up making a crude one to get the job done.  

MSC small transfer screw set:

[attachment=18330]


4 sizes #4-40, #6-32, #8-32, #10-24 plus handle all in a nifty case.

The local GoodWill stores were having a sale today so we hit 3 of them.  The first was the best.  We got there first thing in the morning and on the bottom shelf I found a bag of drill bits, some wrenches and 1/4" drive sockets.  I just put them in my cart when one of the guys that works there walked up with an even larger tub of tools and asked if I wanted them.  Of course I said yeah.  This one 3/8 and 1/2" drive sockets and ratchets.  I just checked them out and the brands are mixed but there are a lot of Craftsman, SK Wayne and Snap On in there.   Of the drill bits I checked out, they're sharp too.   Here are a few pics:










Ignore the red thing, it's my razor knive I used to cut some of the packing tape.



The drill bits were 3.99, the tub with the wrenches and 1/4" drive sockets was 4.99 and the large tub was 5.99.  Then, since we bought over $35.01 worth of stuff, we got 30% off as well.   Not bad for a Monday!

(05-29-2023, 01:27 PM)Vinny Wrote: [ -> ]The drill bits were 3.99, the tub with the wrenches and 1/4" drive sockets was 4.99 and the large tub was 5.99.  Then, since we bought over $35.01 worth of stuff, we got 30% off as well.   Not bad for a Monday!

Roger made me do it. 5C collet stop.

Ed

[attachment=18375]

Ooooh, a Starrett box.  

Ed

[attachment=18397]

(07-22-2023, 10:49 PM)EdK Wrote: [ -> ]Ooooh, a Starrett box.  

Ed