Hmm, I'm not having any of those problems with mine. Although I've not used the full radius inserts yet. Probably because I don't think I have any.
Ed
My Nikcole insert does not sit in line or parallel with the tool holder either, like you i was thinking it was a dud.
I have had a little trouble with chatter too but also success so my story is the same as yours.
I am waiting to purchase the threading bits to try them out, i am waiting on a silly cheap post on fle-bays to snatch them up like i did last time on some parting off inserts, I robbed they guy by paying $2.00 each for ten.
Anthony.
(09-18-2015, 06:43 AM)Mayhem Wrote: [ -> ]I spotted a Starrett S-828H centre finder set, which he was asking $25 for, which followed me home.
Nice find Darren.
We call them wigglers over here and they are nice, but not as accurate as the pin type edge finders. I use mine mostly for the point to pick up center punch marks or scribed lines, and for holding indicators.
Tom
This lot arrived this week (the chemicals and beakers on the tray) , mostly for project X
Still waiting for a few things to turn up , the depleted Uranium must be stuck at customs
Rob
Good one Rob - that post will get the site on a FBI watch list and your address highlighted with major crimes division in the UK... I do hope that the chap with the rubber gloves is gentle
The Lads at work have taken to calling me Bomber Bob
Rob
looks like your fixing to maybe do some anodizing of aluminum
A couple more items scratched off of the "wish" list. Some recent flea-bay steals.
1/2" thick parallels.
Adjustable parallels.
Automatic drill drift.
Wavy parallels still enroute....
[
attachment=11845]